eka KF 1010 UD Use And Instruction Manual page 18

_ TECNOEKA Srl __________________________________________________________ use and instruction manual _
5.6 Possible faults 5.6 5.6 5.6 Possible faults Possible faults Possible faults
Type of fault Type of fault
Type of fault Type of fault
Control panel completely off
(the oven does not work)
Cooking cycle set on the
ON\OFF button pressed: the
oven does not work
Humidity Cycle/ steam
activated: no humidity is
produced in the cooking
chamber
Door closed: steam comes
out of the seal
The oven does not cook
evenly
Lighting lamp in the cooking
chamber does not work
5.7 5.7 5.7 Possible Alarms 5.7 Possible Alarms Possible Alarms Possible Alarms
T T T T ype of alar ype of alarm m m m
ype of alar ype of alar
The wording "Er1" "Er1" appears on the "Er1" "Er1"
display and a sound alarme for 3
seconds. Il heating process is
disactived.
"Er2" "Er2"is displayed on the display "Er2" "Er2"
and an alarm is activated for 3
seconds.
"Er3" "Er3" "Er3" "Er3"is displayed on the display.
The heating process of the oven is
disactived.
_ page 18 _________________________________________________________________________________________
Cause Cause
Cause Cause
- Incorrect electric connections to the
mains
- No mains voltage
- Thermal break safety device tripped
- Electronic card protection fuse (power)
burnt
- Door open or ajar
- Damaged device (switch) door
- Incorrect connection to water mains
- Cut-off cock closed
- Blocked water inlet filter
- Damaged water inlet solenoid
- Seal not fitted correctly
- Damaged seal
- Handle prong loosened
- One of the motors is blocked or turns
slowly
- The motors do not go into reverse
- Heating element not powered or is
damaged
- Damaged lamp
- Damaged lamp feeder
Cause Cause Cause Cause
- Break in the connection between the
cooking chamber probe – electronic
(power) card
- Damaged cooking chamber probe
- Break in the connection between the
cooking chamber probe / electronic
(power) card
- Damaged heart probe
- Overtemperature at risk of damage
to electronic card/microprocessor.
Heat sources too close to the oven.
Corrective action Corrective action
Corrective action Corrective action
- Check the mains connection
- Restore mains voltage
- Reset the thermal break safety device
- Change the fuse
- Close the door
- Contact a qualified technician to
repair the sensor
- Check the connection to water
mains
- Check the cut-off cock
- Clean the filter
- Contact a qualified technician to
repair the solenoid
- Check the seal fitting
- Contact a qualified technician to
repair the seal
- Contact a qualified technician to
repair the prong
- Contact a qualified technician to
repair the motor
- Contact a qualified technician to
repair the motor
- Contact a qualified technician to
repair the element
- Change the lamp
- Contact a qualified technician to
repair the feeder
Solution Solution Solution Solution
- Check the connection to the
electronic card
- Contact a qualified technician to
repair the probe
- Check the connection to the
electronic card
- Contact a qualified technician to
repair the probe
- Wait for the temperature of the
electronic card enters within the
limits of operation. Remove
from the oven sources of heat.
The oven
resumes.
automatically