Table of Contents
Advertisement
T R O U B L E S H O O T I N G
It may occur that the hob does not function or does not function properly. Before calling Caple
service for assistance, lets see what can be done.
First of all, check to see that there are no interruptions in the gas and electrical supplies, and, in
particular, that the gas valves for the mains are open.
T H E B U R N E R D O E S N OT L I G H T O R T H E F L A M E I S N OT C O M P L E T E A R O U N D T H E B U R N E R
C H E C K I F ;
- The gas jets on the burner are not clogged;
- All of the movable parts that make up the burner are mounted correctly;
- There are no draughts around the cooking surface.
T H E F L A M E D O E S N OT S TAY L I T;
C H E C K I F ;
- You press the knob all the way in.
- You keep the knob pressed in long enough to activate the safety device.
- The gas jets are not clogged in the area corresponding to the safety device.
T H E B U R N E R D O E S N OT R E M A I N O N W H E N S E T TO ' L O W '
C H E C K I F ;
- The gas jets are not clogged.
- There are no draughts around the cooking surface.
- The valve has been adjusted correctly (see 'Valve adjustment').
T H E C O O K W A R E I S N OT S TA B L E
C H E C K I F ;
- The bottom of the cookware is perfectly flat.
- The cookware is centred correctly on the burner.
- The support grids have not been inverted
If, despite all of these checks, the hob does not function properly and problems persist, call our
Caple Service department for help
T – 0117 938 7420 E – service@caple.co.uk
12
Instruction manual C886G | C887G | C889G
Please keep this instruction manual for future reference
I N S T A L L A T I O N I N S T R U C T I O N S
Installation should only be attempted by a qualified installer so that the installation and
maintenance procedures may be followed in the most professional and expert manner possible.
I M P O R TA N T:
Unplug the electrical connection before performing any maintenance or regulation upkeep work
P O S I T I O N I N G F O R G A S H O B
I M P O R TA N T:
This unit may be installed and used only in permanently ventilated rooms according to British
standards and gas safe regulations.
- The room must be fitted with a ventilation system which vents smoke and gases from
combustion to the outside. This must be done by means of a hood or electric ventilator that turns
on automatically each time the hood is operated.
- The room must also allow for the influx of the air needed for proper combustion. The flow of air
for combustion purposes must, not be less than 2m³/h per kW of installed capacity. The supply of
said air can be effected by means of direct influx from the outside through a duct with an inner
cross section of at least 100cm² which must not be able to be accidentally blocked.
- Intensive and prolonged use of the appliance may necessitate supplemental ventilation, e.g.
opening a Window or increasing the power of the air extraction system.
Please keep this instruction manual for future reference
Instruction manual C886G | C887G | C889G
13
Advertisement
Table of Contents
