Attaching The Switch Housing - NOMA Lakeside 52" Owner's Manual

Note: Before starting installation, disconnect the power
by turning off the circuit breaker or removing the fuse
!
at the fuse box. Turning power off using the fan switch is
not sufficient to prevent electric shock.
1. Remove 1 of the 3 screws from the mounting ring and loosen the
other 2 screws. Do not remove them.
2. While holding the switch housing under your fan, snap
together the wire connection plugs.
3. Carefully push all wires back into the switch housing. Place
the key holes on the switch housing over the 2 screws
previously loosened from the mounting ring, turn the switch
housing until it locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws previously loosened
and the one previously removed. (Fig. 12)

Attaching the Switch Housing

Wire connection
plugs
Switch housing
8
Mounting ring
Screws
Fig. 12