Installing The Light Kit - NOMA Lakeside 52" Owner's Manual

Note: Before starting installation, disconnect the power
by turning off the circuit breaker or removing the fuse
!
at the fuse box. Turning power off using the fan switch is
not sufficient to prevent electric shock.
1. Remove the 1 of the 3 screws from the switch housing and keep it
for future use. Loosen the other 2 screws. Do not remove them.
2. While holding the light plate under your fan, make the polarized
plug connections:
- White to white
- Blue to black
3. Place the key holes on the light plate over the 2 screws
previously loosened from the switch housing, turn the light plate
until it locks in place at the narrow section of the key holes.
Secure by tightening the 2 screws previously loosened and the
one previously removed. (Fig. 13 )
4. Install three 40 W E12 bulbs (not included). (Fig.14)
5. Raise the glass shade up against the light plate and secure it to the fan
by twisting the glass clockwise until snug. Do not overtighten.
(Fig. 14)

Installing the Light Kit

Connection plugs
Light plate
Bulb
(not included)
Glass
shade
9
Switch housing
Screws
Fig. 13
Light plate
Fig. 14