Table of Contents
Advertisement
Appendix
Expand your telephone system
The handsets provided with your telephone system are pre-registered. Each
handset is assigned a number that shows on the handset display. Additional
handsets registered to the telephone system are assigned in sequential
order. For instance, if the telephone system already has HANDSET 1 and
HANDSET 2, the new registered handset is assigned HANDSET 3. This
telephone system accommodates up to 12 handsets.
Add and register a handset (optional)
To make registration easier, read all of the instructions on this page before
you begin.
You can add new handsets (DS3201, purchased separately) to your
telephone system, but each handset must be registered with the telephone
base before use. When first purchased, each expansion handset shows
NOT REGISTERED. You may need to charge the handset before
registering to the telephone base. For more details on battery charging, see
the table on page 3.
To register a handset:
1.
Place the unregistered handset in the telephone base or charger. If
PRESS FIND HS 4 SEC ON BASE does
not appear on the handset screen after
a few seconds, remove the handset and
place it in the telephone base or charger
again.
2.
On the telephone base, press and hold
FIND HANDSET for about four seconds
(until the red IN USE light on the telephone
base turns on) and then release the button.
The handset shows PLEASE WAIT... and
it takes up to 60 seconds to complete the
registration. The handset shows
HANDSET X REGISTERED (X represents the handset number assigned)
and you hear a beep when the registration completes.
•
If the registration fails, the handset shows
the handset, remove the handset from the telephone base and place it back
in. Try the registration process again.
•
You cannot register a handset if any other system handset is in use.
NOT REGISTERED
32
. To reset
Advertisement
Table of Contents
