Product Overview; Operation; Controls - Exmark BRS270CKC36000 Operator's Manual

Operation

Product Overview

Figure 3
1. Wheel clutch lever
2. Handle
3. Broom angle lever
4. Broom drive lever
5. Speed selector lever
6. Traction drive lever
7. Fuel cap
8. Broom
9. Broom height adjustment
pin
Operation
Note: Determine the left and right sides of the
machine from the normal operating position.

Controls

Choke Control
The choke control is the top lever located on the rear
LH side of the engine above the fuel shut-off valve.
The choke is used to aid in starting a cold engine.
Move the lever left to the "ON" position for a cold
start. Do Not run a warm engine with the choke in
the "ON" position.
Throttle Control
The throttle control is located on the rear RH side
of the engine.
The throttle is used to control engine speed. Moving
the throttle control to the left will increase engine
speed and moving it right will decrease engine speed.
Engine On/Off Switch
Located on the RH side of the engine.
Rotate the switch clockwise to the "ON" position
before starting the engine. Rotate the switch
counterclockwise to the "OFF" position to kill the
engine.
Fuel Shut-Off Valve
The fuel shut-off valve is the lower lever located on
the rear LH side of the engine below the choke. The
fuel shut-off valve shuts off the flow of fuel when
the machine will not be used for a few days, when
parking inside a building, and during transport to and
from the job.
Move the lever to the left to shut off fuel. Move the
lever to the right to turn on fuel.
Wheel Clutch Levers
Located below the RH and LH handles.
The wheel clutch levers allow the drive to momentarily
disengage to one or both wheels with the traction
drive lever still engaged. This allows easier turning
and maneuvering the machine (see Figure 4).
14