ABB M25102xC Series Manual page 49

ABB-Welcome
Setting the lock which will be released when swiping the registered card:
1st (LOCK-GND): the lock connected with the LOCK-GND terminals will be released
when swiping the card.
2ND (NC-NO-COM): the lock connected with the NC-NO-COM terminals will be
released when swiping the card.
(8) Reset
#* system password #
Settings # =>
Reset to Factory
Default?
"#" to Confirm
Reset all settings to factory settings, but other information, e.g. user names, logic
addresses and cards information cannot be reset.
(9) Information
#* system password #
Settings # =>
Audio module:
V1.07_131106
Card reader:
View the software information of each modules of the outdoor station.
*Reset the system password of keypad module:
It is possible to reset the system password to factory-setting if you have forgotten it.
The restoration of default factory settings does not delete the rest of the
information programmed on the system, such as user names and other settings.
1. Disconnect the power supply.
2. Reconnect the power
Hold the "program button" for 5s within 30s.
3.
|
=>
Reset # => #
==＞
=>
Information #
∧
Done!
Operation
— 49 —