Yardworks 060-3801-2 Owner's Manual page 14

Assembly
INSTALLING THE TINES (Fig. 5.1-5.6)
The tiller comes with four tines — For correct operation of the unit, the tines must be installed
in the correct order. The tiller may be used with four tines or two tines.
• Disconnect from power source.
• Lean the unit back on its wheels so that it is resting securely with the handlebar on the ground.
Fig. 5.1
B
FLUTE
1. Place the tine (B) onto the shaft. The flute of
tine (B) should face away from the gear box.
(Fig. 5.1)
Fig. 5.3
A
HITCH PIN
3. Place the tine (A) onto the shaft. The flute of
tine (A) should face in toward tine (B). Insert
the hitch pin into the holes that are located on
shaft in order to secure the tines to the tine
shaft (Fig. 5.3).
FRONT
B
GEAR BOX
TINE SHAFT
FRONT
TINE SHAFT
B
Fig. 5.2
B
FELT
FLUTE
2. Place the felt onto the shaft. (Fig. 5.2)
Fig. 5.4
FRONT
A
B
GEAR BOX
4. Place the tine (C) onto the shaft. The flute of
the tine (C) should face away from the gear
box (Fig. 5.4).
14
FRONT
GEAR BOX
TINE SHAFT
C
TINE SHAFT
FLUTE