Assembly
ASSEMBLING THE WHEELS (Fig. 3-4)
The wheels are used to control the depth of operation. To adjust the height of the wheels.
1. Disconnect from power source.
2. Place tiller in a stable position as shown in Fig. 3)
3. Insert the wheel assembly (2) into the support rod (3). (Fig. 4)
4. Pull out on spring-loaded knob (4) and slide wheel shaft up or down depending on the
depth trying to be achieved.
5. The deepest tilling is Position A and highest, Position B.
ROTATE
80º
PULL
Fig. 3
POSITION A - DEEPEST
(2) WHEEL ASSEMBLY
POSITION B - HIGHEST
Fig. 4
13