Hardware Connection - Zte ZXDSL 831A II User Manual

LED No. Color Status
On
Off
Ethernet Green
Flash
On
Rear panel
Figure 3.1-2 Rear Panel of the ZXDSL 831AⅡ
Table 3.1-2 Description of Interfaces on the Rear Panel
Item
RJ-11 connection interface: The equipment is connected to the ADSL line or
DSL
splitter via the telephone line.
USB connection interface: Connect it to the PC computer using the USB
USB
cable.
In the power-on state, you can restore the system to the default configuration
Reset
by using a thin needle to press this slot for five seconds
RJ-45 connection interface: Connect it to the PC computer or other network
Ethernet
devices using the network cable.
PWR Power interface. Connect it to the power adapter.
Power switch

3.2 Hardware Connection

ZXDSL 831AⅡ User's Manual
Note
The USB interface is in the communication status
The Ethernet interface is in the non-communication
status
Data is received or sent on the Ethernet interface
The Ethernet interface is in the communication status
Introduction
7