3Com 6000 Series Installation Manual page 32

32 C 4: C
HAPTER ONFIGURING THE
Powering on the Router
Startup Process
R
OUTER
Perform the following check items before powering on the router:
Whether the power cord and ground wire are correctly connected.
Whether the voltage of the power supply complies with the requirement of the
Router.
Whether the console cable is correctly connected, whether the PC or terminal
for configuration is started, and whether the settings are done.
WARNING: Before switching on the power, locate the power switch in the
equipment room, so that, in case of an electrical accident, power can be turned
off.
1 Power up the Router. Confirm the following while the router is booting:
Whether the LEDs on the front panel are normal.
Whether the configuration terminal display is normal.For the local
configuration, the booting interface displays on the configuration terminal
after the Router is powered on.
2 Upon completion of POST, press <Enter> to begin configuring router.
Self-test on SDRAM
During the process of powering on the router or resetting the router, the
configuration terminal yields the following output first:
Do you want to go on checking sdram? Yes or not(Y/N)