Troubleshooting Application Software Upgrade - 3Com 6000 Series Installation Manual

54 C 7: T
HAPTER ROUBLESHOOTING
Troubleshooting
Application Software
Upgrade
Fault 1
Fault 2
If the parameter settings do not match the above values, please modify the
configuration.
Start the Router, upgrade the software with the TFTP approach, and the system
displays the following prompt:
DownLoad Program To Flash Through Net Port
boot device
unit number
processor number
file name
inet on ethernet (e) : 1.1.1.1
host inet (h)
user (u)
ftp password (pw)
flags (f)
Loading... Loading Failed
Troubleshooting
The fault occurs due to the wrong boot device 'ErrDev' using a wrong
application. To solve the problem, just change "ErrDev" to "wancom" which is
the application upgrade device of 6000 Router.
Start the Router, upgrade the application software with the TFTP approach, and
the following information is displayed:
DownLoad Program To Flash Through Net Port
boot device
unit number
processor number
file name
inet on ethernet (e) : 1.1.1.1
host inet (h)
user (u)
ftp password (pw)
flags (f)
Attached TCP/IP interface to wancom0.
Subnet Mask: 0xffffffc0
Attaching network interface lo0... done.
Loading... Error code 2: Access violation
tftpGet: Error occurred while transferring the file.
A bad file or twisted pair doesn't link correctly!Loading Failed
Troubleshooting
The problem occurs because the file to be downloaded does not exist or the
network cable is not connected properly. To solve the problem, confirm that the
: ErrDev
: 0
: 0
: 6000.bin
: 1.1.1.2
: user
: password
: 0x80
: wancom
: 0
: 0
: 6000.bin
: 1.1.1.2
: user
: password
: 0x80