Advertisement
Assembling the LED Light Fixtures to
the Light-Bar Straps
1. Align the light fixtures with the lenses of the lights
toward the front of the machine
Figure 12
1. Hole (light-bar strap)
2. Carriage bolt (short)
3. Left light-bar strap
4. Harness
2. Align the harness along the left light-bar strap as shown
in
Figure
12.
3. Align the short carriage bolt that you assembled to the
mount bracket for the LED light with the hole in the
light-bar strap
(Figure
4. Assemble the LED light and short carriage bolt to the
light-bar strap with a nut
5. Repeat steps
3
and
6. Torque the nut to 1,878 to 2,542 N∙cm (175 to 225
in-lb)
7. Secure the wire harness to the light-bar straps with
cable ties as shown in
Note: Before tightening the cable ties, make sure that
the LED lights are aligned slightly downward from the
expected final position. This can prevent damage to
the harness connectors if you rotate the lights down.
Note: If you have excess length of wire harness
between the LED lights, bundle the wire harness and
secure it at the center cable tie.
(Figure
12).
5. Cable ties
6. Nut
7. Front of the machine
12).
(Figure
12).
4
for the other LED light.
Figure
12.
4
Installing the Wire Harness to
the Machine
No Parts Required
Procedure
1. Route the wire harness for the LED light kit down the
left light-bar strap and across to the left handle-bar
tube
(Figure
13).
1. Cable ties
2. Route the wire harness up the left handle-bar tube to
the control panel
3. Secure the wire harness to the left light-bar strap and
handle-bar tube with 3 cable ties as shown in
4. At the back of the console, connect the 2-pin connector
of the wire harness for the LED light kit into the
2-socket connector of the wire harness for the LED
light and wireless hour meter harness kit
7
Figure 13
(Figure
13).
(Figure
Figure
13.
14).
Advertisement
