Advertisement
Figure 2
1. Kickstand
2. Locknut
3. Washer
4. Spacer
3. Remove the flange nut, washer, existing spring post (1
inch), and screw (5/16 x 2 inches) from the right side
of the kickstand (A of
Note: Discard the screw (5/16 x 2 inches) and spring
post (1 inch). Retain the flange nut and washer for
installation in step 5.
4. Install the new spring post (1-3/4 inches) on the
kickstand with the new screw (5/16 x 2-3/4 inches);
as shown in B of
Figure
5. Use the flange nut and washer that you retained in
step
3
to secure the spring post to the kickstand (B of
Figure
3).
5. Side plate
6. Screw (5/16 x 1 inch)
7. Spring post (1 inch)
8. Spring
Figure
3).
3.
1. Kickstand
2. Flange nut
3. Washer
4. Existing spring post (1
inch)
6. Remove the 2 bolts (3/8 x 7/8 inch) and 2 lock washers
(3/8 inch) that secure the spring-anchor bracket and
right-side plate to the outer pad of the rear frame of the
machine
(Figure
Note: Discard the bolts; retain the spring,
spring-anchor bracket, and 2 lock washers for
installation in step 7.
1. Outer pad (rear
frame—machine)
2. Right-side plate
3. Spring
3
Figure 3
5. Existing screw (5/16 x 2
inches)
6. New spring post (1-3/4
inches)
7. New screw (5/16 x 2-3/4
inches)
4).
Figure 4
4. Spring-anchor bracket
5. Lock washer (3/8 inch)
6. Bolt (3/8 x 7/8 inch)
Advertisement
