Advertisement
3
Assembling the LED Lights to
the Light Bar
Parts needed for this procedure:
2
LED light
1
Harness
2
Shield
7
Cable tie
Assembling the Wire Harness to the
LED Light Fixtures
1. Connect the 2-pin of the LED light into the 2-socket
connector of the LED light harness
Note: Ensure that the connectors are fully seated and
the latch of the connectors snap together securely.
Figure 10
1. 2-socket connector (LED
light harness)
2. LED light
2. Repeat step 1 for the other LED light and the other
2-socket connector of the harness
3. If assembled, remove the long carriage bolt and nut
that secure the mount bracket to the frame of the LED
light
(Figure
11).
(Figure
10).
3. 2-socket connector
4. 2-pin connector (LED light)
(Figure
10).
1. Wire harness (LED light
kit)
2. Carriage bolt (long)
3. Frame (LED light)
4. Shield
4. Ensure that the short carriage bolt is assembled
through the hole in the bottom of the mounting
bracket as shown in
5. Align the holes in the shield and mount bracket with
the holes in the frame of the LED light as shown in
Figure
11.
Important: Ensure the wire harness has a
generous loop of wire inside the shield. When
adjusting the alignment of the lights, you must not
be able to pull the wire harness tight and strain
the 2-socket connector.
6. Assemble the shield and mount bracket to the frame
of the LED light with the carriage bolt and nut
11).
7. Torque the nut to 429 to 519 N∙cm (38 to 46 in-lb).
8. Repeat steps
3
through
shield.
6
Figure 11
5. Carriage bolt (short)
6. Mount bracket (LED light)
7. Nut
Figure
11.
7
to the other LED light and
(Figure
Advertisement
