Table of Contents
Advertisement
Description
Hitch
Capscrew 3/8–16 x 2" lg.
Flat Washer .40 I.D. x .81 O.D.
Spacer
Locknut 3/8–16
*Clevis pin
*Hair Pin Cotter
*Drive Shaft
Operator's Manual
Parts Catalog
Registration card
Note: Determine the left and right sides of the machine from the normal operating position.
Note: One of the following installation kits is required to
mount the debris blower to the Sand Pro.
Kit Model No. 08858 for Sand Pro 2020 & 3020
Kit Model No. 08859 for Sand Pro 5000 & 5020
Install Wire Harness
1. Mount the relay and wire harness (supplied in
installation kit) to Sand Pro as follows:
On Sand Pro 2020/3020 only – Remove nut from
capscrew securing steering bracket to frame. Insert
relay and black wire from harness onto capscrew and
install nut (Fig. 1).
Figure 1
1. Steering bracket
Qty.
16
1
2
2. Relay
Use
2
8
Mount to blower frame
8
8
2
Secure blower to Sand Pro
2
1
Mount Drive Shaft to Blower
1
Read before operating the machine.
1
1
Fill out and return to Toro.
On Sand Pro 5000/5020 only – Remove nut from
capscrew securing solenoid to frame panel. Insert relay
and black wire from harness onto capscrew and install
nut (Fig. 2).
1
2
Figure 2
1. Relay
2. Disconnect gray wire (neutral switch) from solenoid
and connect to blue wire on harness with #10–24 x .38"
capscrew and nut. Wrap connection with electrical tape.
3. Connect gray harness wire to solenoid post that grey
neutral switch wire was connected.
4. Connect orange harness wire to solenoid post that has a
green wire attached to it.
5. Plug wire harness connector into relay.
6. Route wire harness to right rear corner of Sand Pro
frame. Secure harness and any excess to frame with
wire ties. Make sure harness does not contact any hot or
moving parts.
9
Advertisement
Table of Contents
