Installing The Snowthrower Belt - Toro 79362 Operator's Manual

2
3
6
7
Figure 9
1. Lift rod
2. Spacer washers, 3/4 in.
3. Lift tube
4. Attachment lift
11. Open mid hitch and install handle support (Fig. 10).
Align notch on handle with hitch rod so it does not
rotate.
2
Figure 10
1. Handle support
12. Slide crank handle through hole in support and secure
handle to U–Joint with hairpin cotter (Fig. 11).
Note: Adjust rotor assembly if necessary so handle clears
tractor hood, teeth mesh fully and chute turns freely.
1
4
5
8
m–2787
5. Hairpin cotter–small
6. Spring
7. Eyebolt
8. Locknut, 3/8 in.
1
m–2789
2. Mid hitch
10
1
2
Figure 11
1. Crank handle
2. Support
Installing the Snowthrower
Belt
1. Remove the belt cover. Refer to figure 27.
2. Install the belt onto the clutch. Refer to Replacing the
PTO Belt on page 17.
3. Route belt between belt guide and around idler pulleys
(Fig. 12).
4. Rotate idler bracket to stretch spring and slip belt over
snowthrower pulley (Fig. 12),
1
3
Figure 12
1. Outer groove of (PTO)
power take off
2. Idler pulley
4
3
1292
3. U-joint
4. Hairpin cotter–small
4
2
m–2788
3. Belt guide
4. Snowthrower pulley