Installing The Discharge Chute And Rotator Assembly - Toro 79362 Operator's Manual

2. Position side plates outside housing side flanges, with
cutting edges parallel to side of housing, and secure
with 6 carriage bolts (3/8 x 1 in.) (heads to the inside),
6 washers (3/8 in.) and 6 locknuts (3/8 in.) (Fig. 3).
4
1
5
6
Figure 3
1. Top plate
2. Carriage bolt, 3/8 x 1 in.
3. Washer, 3/8 in.
Installing the Discharge Chute
and Rotator Assembly
1. Assemble upper discharge chute outside and on top of
lower discharge chute with 2 bolts (5/16 x 5/8 in.)
(heads on the inside), 2 washers (5/16 in.) and 2
locknuts (5/16 in.) (Fig. 4).
4
2
Figure 4
1. Upper discharge chute
2. Lower discharge chute
3. Carriage bolt,
5/16 x 5/8 in.
2. Install discharge chute and deflector shield onto
housing with 3 carriage bolts (5/16 x 3/4 in.) (heads to
the inside), 3 washers (5/16 in.) and 3 locknuts (5/16
in.) (Fig. 5).
4
3
3
2
2
5
1281
4. Locknut, 3/8 in.
5. Side plate
6. Cutting edge
1
3
5
1290
4. Washer, 5/16 in.
5. Locknut, 5/16 in.
2
1
Figure 5
1. Discharge chute
2. Deflector shield
3. Carriage bolt, 5/16 x
3/4 in.
3. Install discharge chute rotator assembly into slot in
housing with 3 carriage bolts (5/16 x 1) (head to the
top), 3 pyramidal washers (5/16 in.) and 3 locknuts
(5/16 in.) (Fig. 6).
4. Adjust rotator assembly so that worm gear is at right
angle with chute, the teeth mesh fully and the chute
turns freely. tighten locknut securely.
Figure 6
1. Rotator assembly
2. Carriage bolt, 5/16 x 1 in.
3. Pyramidal washer, 5/16 in.
8
3
4
5
2241
4. Washer, 5/16 in.
5. Locknut, 5/16 in.
5
1
2
3
4
1280
4. Locknut, 5/16 in.
5. Worm gear