Troubleshooting - Toro 79362 Operator's Manual

Troubleshooting

PROBLEM
Snow does not discharge g
Auger does not rotate.
Abnormal vibration.
POSSIBLE CAUSES
1. Discharge chute plugged.
2. Auger does not rotate.
3. Auger speed to low.
4. Forward speed to slow.
1. Snow frozen to auger or
housing.
2. Drive belt tension low.
3. Drive belt is worn, loose or
broken.
4. Drive belt is off pulley.
5. Drive chain broken.
1. Snow frozen to auger.
2. Drive belt off pulley.
3. Engine mounting bolts are
loose.
4. Loose engine pulley, idler or
snowthrower pulley.
5. Engine pulley is damaged.
20
CORRECTIVE ACTION
1. Clean chute with a stick.
2. See auger does not rotate.
3. Move throttle to fast.
4. Increase ground speed.
1. Scrape snow off with a stick.
2. Adjust belt tension.
3. Install new drive belt.
4. Install blade drive belt and
check idler pulley and belt
guides for correct position.
5. Replace or repair chain.
1. Scrape snow off with stick.
2. Install drive belt and check idler
pulley for correct position.
3. Tighten engine mounting bolts.
4. Tighten the appropriate pulley.
5. Contact Authorized Service
Dealer.