Removing The Snowthrower - Toro Wheel Horse 79263 Operator's Manual

1
2
Figure 18
1. Crank handle
2. Support

Removing the Snowthrower

Note: Save all hardware use when installing the
snowthrower.
1. Park the tractor on a flat surface, disengage the PTO, set
the parking brake, stop the engine, and remove the key.
2. Raise the attachment lift to the transport position and
place a block under the snowthrower housing.
3. Turn the Dial-a-Height knob all the way
counterclockwise and lower the attachment to the
mounting position; refer to Operation.
4. Remove the hairpin cotter at the U-joint and slide the
crank handle out of the support (Fig. 19).
1
2
Figure 19
1. Crank handle
2. Support
4
3
1292
3. U-joint
4. Hairpin cotter, 1-7/8 in.
4
3
1292
3. U-joint
4. Hairpin cotter
5. Remove the hairpin cotters and unhook the rod of the
crank handle support from the cross shaft (Fig. 20).
Figure 20
1. Hook
2. Pin
6. Pull on the idler pulley (Fig. 21) to relax belt tension
and remove the drive belt from the snowthrower pulley.
Remove the drive belt.
7. Remove the hairpin cotters and clevis pins from the
front latch lever and rear hook. Unhook and remove the
idler pulley assembly (Fig. 21).
4
2
5
1294
1
Figure 21
1. Idler pulley
2. Drive belt idler assembly
3. Front latch lever
8. Raise the attachment to the transport position and place
a block under the snowthrower housing.
9. Unhook the rod handle from the lift arm and rotate it
down to relieve spring tension (Fig. 22).
14
3
4
1
2
1286
3. Bracket
4. Hairpin cotter
3
4
5
4. Clevis pin
5. Hairpin cotter