Toro Wheel Horse 79263 Operator's Manual page 10

4
1
5
6
Figure 3
1. Top plate
2. Long shoulder bolt,
3/8 x 1 in.
3. Washer, 3/8 in.
2. Position the side plates outside the housing side flanges,
with the cutting edges parallel to side of the housing,
securing them with 6 long shoulder bolts (3/8 x 1 in.)
(heads on the inside), 6 washers (3/8 in.), and 6 locknuts
(3/8 in.) (Fig. 3).
Installing the Discharge Chute
and Rotar Assembly
1. Install the lower discharge chute and deflector shield
onto the housing with 3 carriage bolts (5/16 x 3/4 in.)
(heads to the inside), 3 washers (5/16 in.), and 3
locknuts (5/16 in.) (Fig. 4).
2
1
Figure 4
1. Discharge chute
2. Deflector shield
3. Carriage bolt, 5/16 x
3/4 in.
4
3
3
2
2
5
1281
4. Locknut, 3/8 in.
5. Side plate
6. Cutting edge
3
4
5
2241
4. Washer, 5/16 in.
5. Locknut, 5/16 in.
2. Assemble the upper discharge chute section outside and
on top of the lower section with 3 bolts (5/16 x 5/8 in.)
(heads on the inside), 3 washers (5/16 in.), and 3
locknuts (5/16 in.) (Fig. 5).
4
2
1. Upper section
2. Lower section
3. Bolt, 5/16 x 5/8 in.
3. Install the discharge chute rotator assembly into the slot
in the housing with a carriage bolt (5/16 x 1 in.) (head
to the top), pyramidal washer (5/16 in.), and locknut
(5/16 in.) (Fig. 6).
1. Rotator assembly
2. Carriage bolt, 5/16 x 1 in.
3. Pyramidal washer,
5/16 in.
4. Adjust the rotator assembly so that the worm gear is at
right angle with the chute, the teeth mesh fully, and the
chute turns freely. Tighten the locknut securely.
10
1
3
5
Figure 5
4. Washer, 5/16 in.
5. Locknut, 5/16 in.
5
1
2
3
4
Figure 6
4. Locknut, 5/16 in.
5. Worm gear
1290
1280