Toro Wheel Horse 79263 Operator's Manual page 13

3
1
2
6
Figure 14
1. Rod handle
2. Lift arm
3. Welded washers
12. Hook one end of the lift assist spring into the outer slot
in the forward angle of the mounting bracket under the
left fender (Fig. 14).
13. Hook the lift assist spring between the welded washers
on the rod. Rotate the rod handle up and hook it over
the tractor lift arm (Fig. 14).
14. Raise the attachment to the transport position, remove
the block under the housing, and lower the
snowthrower.
15. Hook the idler pulley assembly, rear hook onto the
tractor lift shaft (Fig. 15).
3
1
4
1294
Figure 15
1. Rear hook
2. Front hook
16. Rotate the front latch hook up to engage the cross shaft
(Fig. 15).
4
5
3
1567
4. Bracket (outer slot)
5. Lift assist spring
6. Rod hook
2
3
4
3. Clevis pin
4. Hairpin cotter, 1-7/16 in.
13
17. Secure it with 2 clevis pins and 2 hairpin cotters
(1-7/16 in.) at the rear hook and the front latch hook
(Fig. 15).
18. Route the belt around the snowthrower pulley, idler
pulleys, and the upper groove of the electric clutch
(Fig. 16).
1
Figure 16
1. Idler pulley
2. Snowthrower pulley
19. Hook the end of the crank handle support over the cross
shaft (Fig. 17).
Figure 17
1. Hook
2. Pin
20. Rotate it to align the pins with the holes in the handle
bracket and secure it with 2 hairpin cotters (1-7/8 in.)
(Fig. 17).
21. Slide the crank handle through the hole in the support
and secure the handle to the U-joint with a hairpin
cotter (1-7/8 in.) (Fig. 18).
Note: Adjust the rotor assembly if necessary so the handle
clears the tractor hood, the teeth mesh fully, and the chute
turns freely.
3
2
2242
3. Upper groove of the
electric clutch
3
4
1
2
1286
3. Bracket
4. Hairpin cotters, 1-7/8 in.