Advertisement
Figure 9
1. Flange head bolt, 1/4 x 3/4
inch
2. Cab bracket
3. Flange nut, 1/2 inch
4. Headlight assembly, left
hand
4. Loosely mount the end of the headlight bracket to the
side of the cab bracket with a 1/4 x 3/4 inch flange
head bolt and 1/4 inch flange nut
5. Tighten the fasteners securing the headlight bracket.
6. Repeat the procedure to install the right hand headlight
bracket to the right hand cab bracket
7. Fasten the right hand and left hand headlight assemblies
to the headlight brackets
the fasteners supplied with the lights. Make sure the
turn signal lens on the headlight is positioned toward
the outside of the machine.
g028605
5. Flange nut, 1/4 inch
6. Cable ties
7. Flange head bolt, 1/2 x
1-1/4 inch
(Figure
9).
(Figure
10).
(Figure 9
and
Figure
10) with
1. Headlight assembly, right
hand
2. Headlight bracket, right
hand
3. Flange head bolt, 1/4 x 3/4
inch
4. Cab bracket
8. Route the headlight wiring harness underneath the
front edge of the operator's platform and up to the
headlights
(Figure
9. Plug one of the harness connectors into the previously
unplugged harness connector and one into the
headlight. Secure the harness connectors to the tab
on the bracket with a cable tie
procedure on the other headlight.
10. Using the holes in each headlight bracket, secure the
harness, to the bracket with cable ties as shown in
Figure
9.
11. Install the steering tower cover with the screws
previously removed.
Note: The existing front and rear cab lights cannot be
used for CE applications. Disable the front and rear
cab lights as follows:
•
Front-Pop the lights out of the cab roof and
disconnect the wires from the lights. Reinstall the
lights into the cab.
•
Rear-Remove the screws securing the lenses to
lights. Remove the bulbs from the lights and
reinstall the lenses to the lights.
6
g028606
Figure 10
5. Flange nut, 1/2 inch
6. Flange nut, 1/4 inch
7. Tab
8. Flange head bolt, 1/2 x
1-1/4 inch
3).
(Figure
10). Repeat this
Advertisement
