Toro 30639 Installation Instructions Manual page 8

Figure 13
1. Rear bumper bracket bolts and nuts
2. Using the bolts and nuts previously removed, secure a
lamp assembly to the bracket and frame
1
2
3
G016538
Figure 14
1. Nuts previously removed
2. Rear bumper bracket
3. Cable tie
3. Repeat the procedure on the other side of the machine.
4. Following the traction unit main wiring harness, route
the rear light wiring harness to the right rear lamp as
follows:
•
Under the hood support bracket
•
Under the valve
•
Along the existing hard line and wiring harness to
the radiator support
•
Over the radiator hose
•
Down under the frame shroud
(Figure
5
4
4. Rear lamp assembly
5. Bolts previously removed
(Figure 15).
(Figure 15).
(Figure 15).
(Figure 15)
(Figure 15)
14).
1. Hood support bracket
2. Valve
3. Radiator support
•
Affix a cable tie mounting pad to the under side of
the frame, behind the rear axle and approximately
7 inches (17.8 cm) from the right frame rail
16).
Important: Make sure the mounting surface is
cleaned with rubbing alcohol before installing
the mounting pad. Press and hold the
mounting pad for 15 seconds when installing.
8
Figure 15
4. Radiator hose
5. Frame shroud
(Figure