Intended use
The door bolt 843G is an electrically operated magnet bolt for (additional) locking
of gates and large doors in the private or commercial sector, both indoors and
outdoors. For the intended function of the door bolt, the accompanying lock
counterpart with a magnet for detecting that the door is open must be mounted.
In conditions where there is the possibility of frost or low air temperatures, in
conjunction with wind, the door bolt must also be fitted with suitable insulation
material. Switch on the bolt heating („DIP switch", Seite 30).
The electrical installation and mounting must be carried out by specialist
tradesmen from the relevant trade or trained persons.
The door bolt can be mounted vertically with locking mechanism facing down-
wards or surface-mounted horizontally („Assembly examples").
To avoid trip hazards, the door bolt and lock counterpart must not be mounted in
the ground.
The USB connection is designed for factory use and must not be connected.
The device is suitable for installation and use as per these instructions. It is not
intended for any other type of use.
Assembly examples
25
Notes
EN