Override And Automatic Return Operation - Omron H5F Instruction Manual

13. Override and automatic return operation

In Override and automatic return operation, the status can be set to ON or
OFF directly using the Out ON/OFF switch. This status is then held until
the next ON/OFF operation based on the regular settings.
【Example１】 Regular setting: ON at 8:30 am; OFF at 5:15 pm
Use the following procedure to start operation at 7:00 am
for the present day only.
7:00 am 8:30 am
① Change the setting of the Out ON/OFF switch from Auto to ON.
② Return the setting of the Out ON/OFF switch from ON to Auto
while holding down the
point at which this operation is perfomed (indicated by the arrow) until
the next (regular) OFF time.
【Example２】 Regular setting: ON at 8:30 am; OFF at 5:15 pm
Use the following procedure to stop operation at 3:00 pm
for the present day only.
8:30 am
① Change the setting of the Out ON/OFF switch from Auto to OFF.
② Return the setting of the Out ON/OFF switch from OFF toAuto
while holding down the
point at which this operation is perfomed (indicated by the arrow) until
the next (regular) ON time.
≪Note≫
• This operation is possible in run mode only.
• Override and automatic return operation can be cleared by setting the Out ON/OFF
switch to the opposite of the present status. For example, if the output is ON, partial
automatic operation can be cleared by setting the Out ON/OFF switch to OFF.
• Override and automatic return operation cannot be set or cleared if power is not
being supplied to the Time Switch.
• Override and automatic return operation is cleared if any of the settings are changed.
Present day
5:15 pm
WRITE
Present day
3:00 pm 5:15 pm
WRITE
Next day
8:30 am
Key. The ON state will be held from the
Next day
8:30 am
Key. The OFF state will be held from the
- 23 -
5:15 pm
AUTO
5:15 pm
AUTO
ON
OFF
ON
OFF