Appendix
A. Troubleshooting
Status LED
The following table lists the LED patterns in general.
Condition
Loading system after power on
During booting procedure
Detecting and setting network
After network is setup (system up)
During the upgrade firmware process
Reset and restore
There is a button in the back of the Network Camera. It is used to reset the system or
restore the factory default settings. Sometimes resetting the system sets the system
back to normal state. If the system problems remain after reset, restore the factory
settings and install again.
RESET:
Click on the button.
RESTORE:
1. Press on the button continuously.
2. Wait for self-diagnostic to run twice.
3. Free the button as soon as the second self-diagnostic starts.
LED color
Steady green and blink red (once)
Blinking red
Steady green till IP address is confirmed
Blinking green every other second and
steady red
Blink green / orange every second and fast
blink red
- 64 -
Restoring the factory
defaults will erase any previous
settings. Reset or restore the
system after power on.
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532