Emergency override no code 15 min. power disconnect TPM code used Key violation (key left on for 6 mins. without starting) Note: Not all recalls apply to your jurisdiction. Please contact your Program Service Coordinator to confirm what recalls apply. WR3 Troubleshooting Guide...
• Permanent Lockout 72 Indicates reset/sub code (98:XX) Lockout date has expired • Permanent Lockout 80 Indicates reset/sub code (01:XX - 90:XX) Lockout date has expired Note: when a permanent lockout occurs, please contact your Program Service Coordinators for instructions. WR3 Troubleshooting Guide...
• If the voltmeter displays 10V or below, then the battery needs to be replaced. • If the battery has been discharged more than twice, then the integrity of the battery has decreased. Note: Check all wiring connections between the interlock system and the vehicle, including proper grounding. WR3 Troubleshooting Guide...
Calibration/Download station so that a Handset Return transaction can be completed under the client’s name. Note: If the Handset Return transaction cannot be completed for whatever reason, immediately send back the handset to ACS, and label the handset DATA IN. Interface Module Exchange Procedure 1.
Note: An invalid sample may occur due to excessive moisture in the handset. To speed up the drying process, remove the mouthpiece from the handset and “whip” the handset as if you were drying off a water bottle or a paint brush. WR3 Troubleshooting Guide...
Page 12
Handset battery - Defective handset - Perform a handset exchange Battery Error error battery procedure - Return the old handset to ACS HS RTC Error Handset real time - Real time clock not - Perform a handset exchange clock error running...
Page 13
- Perform an interface module - Defective interface exchange procedure module Technical Error Interface module - Voltage spike from 12V - Perform an interface module analog fuse blown source exchange procedure - Return the old IM to ACS WR3 Troubleshooting Guide...
Blank display -Vehicle’s battery is weak - Boost or charge the vehicle’s battery - LED is not blinking or dead - Just shows ACS on the screen Start Motor -Engine cranks but wont - Boost or charge vehicle’s battery start...
Need help?
Do you have a question about the WR3 and is the answer not in the manual?
Questions and answers