CODELOCKS Kit-Lock KL1100 Getting Started Manual page 5

2. Present the Master Card to the lock.
3. On the Programmer enter either:
a) Public Function: #
b) Private Function: #
4. To exit programming mode, unplug the Programmer. The Red LED will flash once
within 5 seconds to confirm.
USING THE LOCK - PUBLIC FUNCTION
The lock will remain open until the next user touches a compatible card to the front of the
lock. Once locked, the lock will only be able to be opened by the same card that was
used to lock the lock, the Master Card or the Technician Card.
If the Master Card is used to open the lock, the existing User Card will be deleted.
If the Technician Card is used to open the lock, the existing User Card will be retained
and after 5 seconds, the lock will re-lock.
Add / Remove a Technician Card
1. Plug the Programmer into the lock.
2. Present the Master Card to the lock.
3. Press: # ••
Present a card to the lock within 5 seconds while the Blue LED is flashing:
a) If the card has not already been added to the lock, the Blue LED will flash and
it will be added. This is now a Technician Card.
b) If the card has previously been added, the Red LED will flash and it will be
removed.
4. Wait 5 seconds for the Blue LEDs to stop flashing.
5. To exit programming mode, unplug the Programmer. The Red LED will flash once
within 5 seconds to confirm.
Note: Up to 10 Technician Cards can be registered at any one time, per lock.
Remove all Technician Cards
1. Plug the Programmer into the lock.
2. Present the Master Card to the lock.
3. Press: # ••
4. To exit programming mode, unplug the Programmer. The Red LED will flash once
within 5 seconds to confirm.
•• 24 •• 24
•• 26 •• 26
04 ••
05 •• 05 ••
••
••
4