Factory Reset - CODELOCKS Kit-Lock KL1100 Getting Started Manual

Disable Time, Date and Time Based Features
1. Plug the Programmer into the lock.
2. Present the Master Card to the lock.
3. Press: # ••
4. To exit programming mode, unplug the Programmer. The Red LED will flash once
within 5 seconds to confirm.
OVERRIDE CODE
This 4 digit code can be used to unlock in the event that the Master Card is not available.
The default Override Code is: # # 2244.
Set Override Code
1. Plug the Programmer into the lock.
2. Present the Master Card to the lock.
3. Press: # ••
4. To exit programming mode, unplug the Programmer. The Red LED will flash once
within 5 seconds to confirm.
Use Override Code
1. Plug the Programmer into the lock.
2. Press: # #
3. The lock will unlock.

FACTORY RESET

The KL1100 can be factory reset using the button in the latch unit, or via the
Programmer.
Via Reset Pinhole Button
1. Open latch unit battery compartment and remove 1 battery.
2. Using a paperclip, press and hold the reset button located in the pinhole.
3. Replace battery and then release the reset pinhole button. The Blue LED will
flash twice.
4. Once you see the Purple LED flash, press the reset pinhole button three times in
quick succession.
12 •• 0000000000
98 •• New Override Code
•• Override Code
••
•• Repeat New Override Code
••
9
••