Retrieving Measured Values From The Buffer; Retrieving Measured Values From The Memory; Clear Button - KALEAS LDM 500-80+ Operating Instruction

LDM 500-80 +

Retrieving measured values from the buffer

The buffer allows quick access to a single memory value. The buffer
is ideally suited if you plan to use a value multiple times.
1x
short
1x
short
 Example: You want to determine the volumes of several rooms with
the same ceiling height. Measure the room height once and store
the value to the buffer by pressing the [T2] button longer than 2
seconds. Then insert the value as the height when using the volume
function by pressing buttons [T2] and [T1] successively to retrieve
the value and apply it.

Retrieving measured values from the memory

2x
1x
short
1x
short
Optional:
1x
>2 s
 The representation of a stored value corresponds to its origin. In the
case of functions and calculations, the corresponding units of
measurement and individual values are also displayed, e.g., in the
case of a surface area, these are two length values and one surface
area value.

Clear button

1x
short
© KALEAS GmbH & Co. KG
ENGLISH
 Display [10]
 Display [4]
The value is available for use in all functions.
 Display [10]
Invoking the desired memory address n
 Display [11] 1...99
 Display [4]
The measured value is available for use in all
functions.
 Display [10]
The value from the display [4] is saved to the buffer
and memory address 1.
The last operation is reset, for example an erro-
neous single value during the execution of a
Value from buffer
Indicates active memory address
Apply value from memory address n
37