Inclination / Indirect Vertical Distance; Segment Measurement - KALEAS LDM 500-80+ Operating Instruction

continuous measurement option. The determined minimum value is
used automatically for the Pythagorean calculation.
 The computed result may also be greater than 80 m.

Inclination / indirect vertical distance

The device is equipped with an integrated inclination sensor.
 Please ensure that the meter is inclined less than 10º about the lon-
gitudinal axis during the inclination measurement (error 156).
1x
short
1x
short
1x
short
>1 s  Display [4]
 The computed result may also be greater than 80 m.

Segment measurement

This measurement is used to quickly determine a recurring distance.
This is helpful, for example, when installing timber framing or joists,
or when in-stalling roof battens, where equal distances should be
maintained between all timers or joists or the roof laths.
An acoustic tone interval sounds off when the measured distance
approaches the set segment distance or a multiple of the same with
a distance of 0.1 m. As soon as the remaining distance has reached
or dropped below 0.002 m, the pitch of the signal changes.
34
2
3
1
The inclination sensor is activated.
 Display [6]
 Display [2]
Laser [B] is activated, meter is ready for measuring.
 Display [6]
Measuring segment 2.
 Display [6]
 Display [4]
 Display [2]
 Display [3]
LDM 500-80
Measured angle of inclination α
from the horizontal in degrees
, the corresponding line is flashing.
, the vertical line is flashing.
Calculated length x
Measured angle of inclination α
Measured segment 2
Switches between segment 3
(horizontal) and segment 1 (vertical)
+
ENGLISH
© KALEAS GmbH & Co. KG