Installing The Identification Reader(Msr/Ibutton/Fingerprint/Rfid/M+I) (Optional) - Datavan Saturn Series User Manual

Installing the Identification Reader
(MSR/iButton/Fingerprint/RFID/M+i) (Optional)

WARNINN:
Be sure to turn off the power of the Touch Terminal before making any
connection or disconnection.
NOTE:

• The identification reader can be installed on either side of the Touch Terminal.
1. Remove the screw securing the HDD/identification reader compartment cover to the Touch
Terminal. (a)
2. Detach the HDD/identification reader compartment cover from the Touch Terminal.
3. Route the optical identification reader connector through the opening on the support bracket.
4. Align and install the support bracket to the Touch Terminal.
5. Secure the support bracket to the Touch Terminal with the screw.
6. Detach the identification reader compartment cover.
7. Connect the identification reader connector with the optional identification reader connector.
8. Align by the screw holes and then install the identification reader to the support bracket.
9. Secure the identification reader to the support bracket with the two screws.
10. Attach the identification reader compartment cover to the identification reader.
g
HARDWARE INSTALLATION
c
d
e
h
b
f
45
(d)
(e)
(f)
Optical identification reader connector
Opening on the support bracket
i
j
(b)
(c)
(g)
(h)
(i)
(j)