HARDWARE INSTALLATION
Installing / Replacing the HDD
WARNINN:
Be sure to turn off the power of the Touch Terminal before making any
connection or disconnection.
1. Remove the screw from the HDD/identification reader compartment cover.
2. Detach the HDD/identification reader compartment cover.
3. Install the HDD into its compartment in the Touch Terminal, making sure the connectors are
aligned correctly.
4. Replace the HDD/identification reader compartment cover
Installing the Customer Display (Optional)
WARNINN:
Be sure to turn off the power of the Touch Terminal before making any
connection or disconnection.
1. Place the Touch Terminal on a soft and flat surface, with the LCD panel facing down.
2. Remove the connectors cover.
3. Rotate the panel stand to access the screws securing the panel stand to the Touch Terminal.
4. Remove the four screws securing the panel stand to the Touch Terminal.
5. Detach the panel stand.
6. Detach the VESA compartment cover.
7. Detach the customer display compartment cover.
8. Route the customer display cable through the cable compartment on the panel stand.
(c)
(a)
(d)
(e)
(b)
(b)
and secure with the screw.
c
b
(f)
42
(a)
(a)
a
(b)
(c)
(g)