Additional Information; Trouble Shooting - Qviart Undro User Manual

2) If you have set the timer, it will start recording automatically according to the
start time of the timer.
Stop Recording
1) You can press the button to stop recording.
2) If you have set the timer, it will stop recording automatically according to the
stop time of the timer.
3) If the free space on the USB HDD or USB disk is insufficient, recording will
stop.

Additional Information

Trouble Shooting

Before contacting your local service centre, please read the tips below carefully. If the
problem persists after completing the following procedure, please contact your local
product distributor or service centre for further instructions.
1. No message displayed on the front display (The product will not switch on)
•Check the main power cable and make sure it is plugged into a suitable power outlet.
•Check that the mains supply is switched on.
•Connect the power cable to a different power outlet.
•Check that the power switch is on at the rear of the product.(where applicable)
2. No picture
•Make sure that the product is powered on and in operation mode.(Press the
STANDBY button)
•Make sure that the AV/HDMI cable is firmly connected to the TV.
•Make sure that the antenna cable is properly connected to the product.
•Be sure to activate channel search.
•Check the brightness level of the TV.
•Check if the channel is currently on air. Contact the broadcaster to ensure that the
channel is running.
3. Poor picture/sound quality
•Make sure there is no mobile phone or microwave oven near the product.
•[Satellite] Check that your dish alignment is correct.
•[Satellite] Change the satellite dish for a larger one as this will increase the signal
27