Advertisement
ASSEMBLY INSTRUCTIONS - PLEASE READ BEFORE ATTEMPTING ASSEMBLY
Parts List
2 - Handrails
1 - Ladder Section
1 - Platform
Hardware Pack
14 - #10 x 1-1/4" Screws
1 - Threaded Cap
2 - Mounting Blocks
2 - Adjustable Tubes
If missing parts call - Toll free U.S. - 800-635-3213 or www.conferladders.com
Step 1.
Install threaded cap
over bottom drain hole.
Step 4.
Insert tabs on platform
into handrail. Repeat
for 2nd handrail.
2
CONFER PLASTICS, INC.
Model #635-52X
Adjustable
Tubes
Mounting
Blocks
Platform
Step 2.
Pour 5 lbs
of sand
into each leg.
Fill remainder
with water.
Step 5.
Insert wedge into handrail just below the
platfom tab, using rubber mallet tap into
place. repeat to install remaining three [3]
wedges into handrails.
Ladder
Handrails
Step 3.
Tools Needed for Assembly
* Sand - 10 lbs
* Cordless Drill Motor
* 1/8" Drill Bit
* Phillips Screwdriver
* Tape Measure
* Liquid Soap or Lubricant
Using a knife care-
fully remove all
four [4] wedges.
Step 6.
Slide the
handrails onto
the legs.
DO NOT
secure with
screws at
this stage.
Advertisement
