Pioneer DRM-7000 Service Manual page 143

DRM-7000, DRM-AF751, DRM-AL751, DRM-AH721, DRM-PW701
(3) Attaching the Inner Table Assy
1. Mount the Inner Table Assy so that the tip of the Planetary Arm
Assy is centered on the cutout of the Outer Table.
Note : Make sure that the Inner Table Assy is not mounted
on the flange of the Outer Table.
Planetary Arm Assy
Planet Gear
Fig. 5
(4) Mounting the Swing-full Assy
1. Place the unit in the upright position with the left side of the unit
up (right side down). Use a soft cloth such as a rug to protect the
Front Door.
2. Align the largest, key-shaped axis of the H Cam Gear of the
Carriage Base and two SW Arms C with the
3. Turn the Inner Table of the Swing-full Assy completely
counterclockwise and keep it in that position.
Note : Grip the Chuck Assy and the Upper Plate firmly so
that the Inner Table will not return to its original position
under its spring tension.
4. Insert the Steel Ball into the slot of the Outer table.
5. Align the key-shaped slot of the Inner table with the key-shaped
axis of the H Cam Gear, and mount the Swing-full Assy.
Note : While mounting the Inner Table, press it on so that the
Inner Table will not pop up from the Outer Table .
6. Slide the Lock Plate, and lock it.
Note : Check that the Lock Plate is firmly locked by lifting the
Swing-full Assy.
7. Rotate the Swing-full Assy one turn by rotating the Loading
Motor. If the SW C Arms are not seated in the cam grooves, the
rotation will be locked midway. In such a case, remove the
Swing-full Assy and repeat steps 5 through 7.
8. Lay out the wire of the Sensor Stay and screw on the Sensor
Stay.
Outer Table (cutout)
marks.
Loading
Motor Assy
SW Arm B
(to inner cam groove)
marks
SW arms C
marks
Fig. 6
(5) Attaching the SW Arms
1. Attach the SW Arms as indicated in Fig. 7.
Note : There are three SW Arms, labeled A, B and C.
Flexible cord A
H cam gear
Fig. 7
Key-shaped axis of the
H cam gear (largest)
DCMB
SW Arm A
BOARD
(to outer cam groove)
ASSY
SW Arm C
SW Arm C
SW Arm B
(to inner cam groove)
143