Pioneer DRM-7000 Service Manual page 150

DRM-7000, DRM-AF751, DRM-AL751, DRM-AH721, DRM-PW701
REAR PANEL
[ Rear ]
1
3
4
5
TERM
ID
OFF ON
C H A N G E R S C S I
6
1 Rear plates
These plates cover the space for attaching the connector
panels.
2 Rear access door
3 Drive SCSI ports (attached connector panel)
4 SCSI ID switch (ID)
This switch is used to assign the changer SCSI ID. If you
would like to decrement the displayed SCSI ID, push the
small switch just above the numeric display by a nib. And if
you would like to increment, push the small switch just
below the numeric display. Note that SCSI ID is set to '6' at
the time of shipment.
5 SCSI termination switch (TERM)
This switch is for SCSI termination. Note that this switch is
set ON at the time of shipment and it must be kept ON
during the changer installation. But when the SCSI bus
150
2
POWER
OFF ON
A C I N
GND
[ Rear access door INSIDE ]
7
8
connection is completed and the changer is not the last
device on the SCSI bus, it must be set OFF certainly.
6 Changer SCSI ports (CHANGER SCSI)
7 Power switch (POWER)
This switch is used to turn the power to the changer on
and off.
8 Power inlet (AC IN)
The power cord is inserted into this power inlet. (Note that
you should always be sure to use only the power cord pro-
vided with your changer.)
9 Rear bays
The rear bays are designed as the multipurpose bays. For
the 50-disc magazines, these bays are similar to the front
magazine bays and they are assigned M8-M15. But the
rear bays are some
9