Pioneer DRM-7000 Service Manual page 141

DRM-7000, DRM-AF751, DRM-AL751, DRM-AH721, DRM-PW701
Removing the VD Motor Fixing Plate
1
Remove the side panel, located at lower-right viewed from
the front.
2
Remove the four screws (ABZ30P060FMC).
3
Remove the spring, belt and two connectors.
3
Belt
Spring
3
2
×4
Removing the Carriage Base
1
Open the Front and Rear Doors. Turn off the power.
2
Move the Carriage Base Assy down until it touches the under
chassis by manually rotating the shaft of the elevator motor.
Caution: If the Carriage Base Assy does not touch the
3
Two
connectors
3
Remove the four screws (PMB30P060FMC) and remove the
Carriage Base.
Reattaching the Carriage Base
1. Reattach the Carriage Base with the four screws with the
table of the Carriage Base Assy touching the under chassis.
Caution: Be sure to proceed with this step with the Carriage
Entering Adjustment Mode
1. Locate the Carriage Aase Assy at an address between
200 and 250.
2. Proceed the each adjustment.
under chassis, the table of the Carriage Base Assy
will be deformed.
2
4
3
×4
Carriage Base
Base Assy touching the under chassis.
Otherwise, the table of the Carriage Base Assembly
will be deformed.
Carriage base
141