Cabling The Device - AudioCodes Mediant 500L MSBR Quick Setup Manual

Cabling the Device

Cabling depends on your ordered hardware interfaces, for example, the type of WAN interface.
1. (Only if ordered with LTE cellular) Insert the SIM card (supplied by your service provider) into the SIM
slot.
2. Connect the device's WAN port interface to the WAN.
Connect the yellow Gigabit Ethernet ports (labeled GE LAN) to your LAN, using an RJ-45 CAT-5 Ethernet
3.
cable.
4. (Only If ordered with BRI interfaces) Connect the BRI ports (labeled BRI) to your ISDN BRI phones,
ISDN PBX, or ISDN network PBX, using an RJ-48 connector.
5. (Only if ordered with FXS interfaces) Connect the FXS ports (labeled FXS) to your analog telephones or
fax machines.
6. Insert the DC plug that is located at the end of the power cord of the supplied power adapter into the
device's power socket located on the rear panel and labeled POWER. Plug the power adapter directly
into a standard electrical wall outlet. Switch on the device by pressing-in the power button located on
the rear panel. When the device receives power, the Power LED turns on (green).
5 | P a g e