AudioCodes Mediant 500L MSBR Quick Setup Manual page 3

Physical Description of Rear Panel
[Note: The number and type of port interfaces depend on the ordered hardware configuration.]
1 POWER DC power plug entry for external AC/DC power adapter
2 ON / OFF Power button to switch on (pressed in) and off (pressed out) the device.
3 CONSOLE RS-232 serial interface port (RJ-45).
4
USB port, which can be used for storage on an external USB hard drive, or for 3G
cellular WAN modem for primary or backup WAN
5 // Reset pinhole button for resetting the device or restoring it to factory defaults. To
restore to factory defaults: with a paper clip or any other similar pointed object, press
and hold down the button for at least 12 seconds (but no more than 25 seconds).
6 S0 / WAN
WAN interface ports (e.g., copper, DSL or fiber optic), which depend on ordered
interfaces.
7 S1 / GE LAN Up to four Gigabit Ethernet (10/100/1000Base-T) ports (RJ-45) for connecting IP
phones, computers, or switches. The ports support 1+1 Ethernet port redundancy
(active-standby), half- and full-duplex modes, auto-negotiation, and straight-through or
crossover cable detection.
8 Wi-Fi pinhole button for enabling or disabling Wi-Fi. Use a paper clip or any other
similar pointed object to press the button.
9 S2 / FXS, Telephony interfaces (RJ-11 ports for FXS and FXO; RJ-45ports for ISDN BRI).
FXO, BRI
10 -
Cellular antennas for 4G LTE network.
11 SIM card slot for 4G LTE cellular.
12 - Multiple-input and multiple-output (MIMO) 2Tx/2Rx antennas, operating in 2.4 GHz
frequency range for wireless LAN 802.11n/b/g (Wi-Fi) access point.
Green On
Green Flashing
Off
3 |
Ethernet link established
Data is received or transmitted
No Ethernet link
P a g e