Maintenance; Accessories; Spare Parts - WOHLHAUPTER DigiBore 501 Series Operating Instructions Manual

of preventing coolant from entering the
battery compartment. Only batteries with
the following specification must be used
for operating this precision tool:
VARTA V392 SR 41 Sil ver oxide / Zinc /
KOH-Electrolyte. Only these batteries
have been tested in relation to the high
centrifugal forces involved. To change
the batteries, open the battery compart-
ment 3 (Figure 10). Use a Torx T 20 ser-
vice key to open the unit, remove the old
batteries and dispose of them correctly.
Close the battery compartment again
carefully.
Description of the metric display
1
Battery charge display (Low battery)
2
+/– sign
3
Decimal comma
4
Value displayed in mm
Description of the inch display
1
Battery charge display
(Low battery)
2
– sign
5
Comma for inch display
6
Value displayed in inches
4 6
1
2 3
5
Fig. 11

5. Maintenance

The tool needs only to be cleaned after
use and the serrated body lightly grea-
sed. To keep the tools in top class con-
dition and maintain their value, store
them in a dry place and occasionally
cover them with a light film of oil.

6. Accessories

The accessories are not included in the
equipment supplied and must be orde-
red separately.
You can obtain the latest information
on accessories from the Wohlhaupter
product catalogue as well as from the
website: www.digibore.de

7. Spare parts

215 674 Threaded taper pin for
mounting accessories
415 353 Clamping screw for slide
clamping
415 896 Battery (always change
2 batteries)
501 016 Battery access cover
with sealing ring
415 895 Sealing ring for battery cover
115 576 Hexagon wrench SW 4
215 150 Service Key T20
English
15