Table of Contents
Advertisement
STEP 3
CHECKING FOR CONTACT
If necessary, temporarily remove the water block to check for uniform
surface contact between the block and components. Pay special
attention to the VRM section of the graphics card. Check whether the
water block makes contact with the intended integrated circuit. Then
repeat Steps from the previous section to re-attach the block.
In case you fail to obtain good contact, please check again or
contact our support service at www.ekwb.com/support.
STEP 4
INSTALLATION OF FITTINGS AND TUBING
Screw-in two (2) G1/4 threaded male fittings. Attach the liquid
cooling tubes and connect the water block(s) to the cooling loop.
EK-Fitting
EK recommends using EK-Fittings with this water block.
EK- Plug G1/4
You can use any opening as an inlet/outlet port.
Do not forget to plug the remaining two openings with enclosed
EK-Plug G1/4 or its equivalent.
CAUTION: In case of using connectors other than EK Compression
Fittings, pay special attention to the length of the fittings' male G1/4"
Tubing
thread. 5mm is the maximum G1/4" thread length allowed!
STEP 4
- 8 -
Advertisement
Table of Contents
Need help?
Do you have a question about the EK-Pro GPU WB RTX 6000 – Ni + Inox and is the answer not in the manual?