Viking 242-2009-632 Service Manual page 68

LTR-Net PROGRAMMER
4.5.6 MODE SELECT
The Mode Select window places the repeater
either in the Normal mode, Test mode or Diagnostic
mode. In the Normal mode, the repeater operates as a
normal repeater. In the Test mode or Diagnostic Mode
the repeater transmits a test word. This test word is
the Test Mode ID setup in the Repeater Information
(see Section 4.3.3
).
C A U T I O N
While in the test or diagnostics mode the repeater is
"Busy", therefore it is important to place the repeater
in Normal mode when the Test Mode is no longer
required.
TEST
4.6 TEST
Figure 4-25 TEST MENU
March 1999
Part No. 001-2009-600
Exciter
PA
Receiver
Full Repeater
Adjust Switch Link
Figure 4-24 TEST PROGRAMMING FLOWCHART
Figure 4-23 MODE SELECT
All Tests
Repeater Setup
Transmitter Test
Receiver Test
Transmit Audio/Data
Audio Data Adjust
Repeater Operations
NOTE: Some screens may require scrolling down to
read the complete procedure.
4-10