Table of Contents
Advertisement
4.3.4 DELETE REPEATER
Select the Repeater number to delete from this
Locality and press the Delete button.
Figure 4-14 DELETE REPEATER
Figure 4-16 HARDWARE PROGRAMMING FLOWCHART
4.4 TRANSFER
4.4.1 READ SETUP PARAMETERS
peater and loads it into a buffer. The contents of the
buffer may then be displayed to show the programming
of the repeater.
NOTE: This button is only available if a Locality file is
loaded and a repeater is connected.
4.4.2 WRITE SETUP PARAMETERS
peater and programs the EEPROM memory in the Main
Processor Card (MPC).
HSDB Monitor
RX/TX Data
RF Data
HARDWARE
Input Monitor
Revisions
Mode Select
4-7
LTR-Net PROGRAMMER
Figure 4-15 TRANSFER MENU
This menu selection has an equivalent icon in
the toolbar. This menu selection or icon reads
the contents of the EEPROM memory of a re-
This menu selection has an equivalent icon in
the toolbar. This menu selection or icon sends
the contents of a Locality file to a connected re-
Part No. 001-2009-600
March 1999
Advertisement
Table of Contents
