Table of Contents
Advertisement
LTR-Net PROGRAMMER
4.3 EDIT
This menu is used to create new files and set or
change the repeater operating parameters. The file-
name for the Locality and relevant data is shown in the
Title Bar and Status Bar (see Section 4.8.1).
Figure 4-5 EDIT MENU
Delete Entry
Frequency Band
Channel Number
Area Bit
Transmit Frequency
Receive Frequency
Active
Defined Repeaters
OK
Cancel
Help
March 1999
Part No. 001-2009-600
Locality Information
Select Repeater
EDIT
Repeater Information
Delete Repeater
Figure 4-4 EDIT PROGRAMMING FLOWCHART
Table 4-1 DEFINE REPEATERS PARAMETERS
Removes the selected Defined Repeater from the list.
Selects the Locality frequency band, 800 MHz, 800 MHz with offset, (or 900 MHz).
Select a repeater number in the Defined Repeater pane and assign the channel number (1-920).
See Appendix A for an 800 MHz Frequency Chart.
If the coverage area includes more than one Switch the area bit is used, this is normally 0.
This is displayed for reference and is determined when the Channel Number is selected.
This is displayed for reference and is determined when the Channel Number is selected.
Click on this box to activate the selected Defined Repeater.
Click on a repeater number, then select the channel number and the data is displayed.
Saves the current selections shown and closes the window.
Disregards all changes and closes the window.
Displays the Help screen for the parameters in this window.
Define Repeaters
Adjacent Locality Data
Edit Parameters
General Parameters
Input Alarms
Output Alarms
Alarm Cross Reference
4.3.1 LOCALITY INFORMATION
This menu selection has an equivalent icon in
the toolbar. This menu selection or icon
brings up the Locality information screens to
Define Repeaters and Adjacent Localities.
Figure 4-6 LOCALITY CONFIGURAITON
4-2
Advertisement
Table of Contents
