Bernina Q 16 User Manual page 42

Setting up the machine
> Pull in a wide arc around the thread guide (6) in the direction of the arrow.
> Open the service door and check whether the thread is positioned between the two rear thread tension
> Close the service door.
> Guide the thread on the right-hand side of the machine in the direction of the arrow around the thread
> Guide the thread up and thread into the take-up lever (8) from the back to the front.
> Guide the thread down and into the left opening of the thread guide underneath the service door.
> Guide the thread from the right into the thread guide on the needle bar.
> Insert the thread into the needle threader slot.
> Thread it into the left needle using the needle threader.
Threading the right thread
Prerequisite:
•
•
•
> Place the spool on the right spool pin.
42
discs. If not, repeat the previous step.
regulator (7).
The double needle is inserted.
The needle is in the upper position.
The presser foot is raised. This is IMPORTANT so that the thread can be inserted between the thread
tension discs.
6