Table of Contents
Advertisement
Available languages
Available languages
INSTALLATION
INSTRUCTIONS
GENERAL
INFORMATION
LEVEL UNIT
UNPACK
BOTTOM
FLAPS
REMOVE
2
INTERIOR
PACKING
1.
2.
3.
4.
5.
6.
Lay carton
on rear face and break open bottom
flaps.
Set carton upright
with all four flaps outward.
Lift carton up and off of machine.
Remove all tape and packaging
material from the
outside and inside of the cabinet.
Remove the front grill; take out the screws secur-
ing the grill at the bottom and lift if free of cabinet.
Turn the fan by hand to make certain
it moves
freely.
LOCATE UNIT
AIR
FLOW
IMPORTANT
T4
FOR THE PLUMBER
2
OBSERVE LOCAL CODES
1. Place unit so that the front side will be completely
unobstructed,
to provide proper air flow.
2. Area should
be well ventilated
with temperature
above 15°C (SOOF). Best results are obtained between
21°C (70°F) and 32°C (90°F).
3. Provision
for electricity,
water and drain connec-
tions should be determined.
4. The unit may be closed in on the top and three
sides, but the front MUST BE unobstructed
for air
circulation
and
proper
operation.
Installation
should
be such that the cabinet
can be moved
forward for servicing,
if necessary.
After
placing
unit
in position,
check
to make
certain
the unit is level side to side and front to
back.
Accurate leveling is essential for proper operation.
Unit should
be shimmed
so that it is solid as well
as level. The shims should
be of hard permanent
type material such as masonite.
If required
by sanitation
code, seal the cabinet to
the floor with an approved
caulking
compound.
UTILITIES
OBSERVE LOCAL CODES
G
WATER
1
.
DRAIN
3
ELECTRICITY
2
Each installation
is unique but will require:
1. A cold water inlet of 6.35 mm (l/d") OD soft copper
tubing and a shut-off valve.
2. Either a gravity drain system or a sump pump to lift
the water to an existing drain.
3. An electrical
branch circuit of 220/240 Volt, 50 Hz, 1
phase, with a 10 Amp delayed action fuse.
CONNECT
TO WATER
1. Use 6.35 mm (%I") OD soft copper tubing for the cold
water supply.
2. Provide a convenient
manual shut-off valve in the
water Ii ne.
3. Position
the tubing
so it can enter the access hole
located
in the right-hand
rear of the cabinet.
The
tubing
should
extend
beyond
the cabinet
front
when
the cabinet
is pushed
back into position.
See Figure 1.
Advertisement
Table of Contents
