Before You Begin; Tools; Installation Notes; Components - Whirlpool EZ CONNECT Installation Manual

Before You Begin

Tools

Gather required tools and parts before
starting installation. Read and follow the
instructions provided with any tools listed here.
1. Regular screwdriver
2. Phillips screwdriver
3. 7 " and 1 " open-end wrenches (or an
16 2
adjustable wrench)
4. Pliers
1 " nut driver
5.
4
6. Hand drill with 1
7. Small hand level (optional)
3
8. Small -round file
4
9. Tubing cutter
10.Center punch
11.Hammer
12.Scissors
13.Ruler
14.Step stool (optional)

Components

Remove the contents from the shipping carton
and set them on a table where they can be
easily identified and located. Check all of the
components in the kit against the following list
to help you become familiar with them. When
you identify a component, place a check
mark ( 3) after it. The KEY numbers
correspond to the "Component Illustrations."
Do not discard any of the packing material
until you account for all of the components. If
you need to order a replacement part for the
Ice Maker, a replacement parts list is provided
on page 18.
KEY QTY. DESCRIPTION
1 1 Ice maker
2 1 Ice bucket
4
" drill bit
4

Installation notes

1. Follow all of the instructions. Read
through the entire step so that you
understand it before you perform it.
2. The illustrations in this Installation Guide
are meant to clarify the installation steps
you need to perform. For each set of steps
shown, refer to the diagram immediately
beside or below the text for clarification.
Some illustrations also contain "DETAILS."
DETAILS are contained in bubbles
alongside the larger illustration. A DETAIL
shows a close-up illustration of a certain
portion of a diagram or an illustration of a
specific step you are to perform. DETAILS
are labeled A, B, C or D and are clearly
referenced in each step.
3. When you are instructed to install a part,
position the part as shown in the illustration.
BE FO RE
COMPONENT ILLUSTRATIONS