Fayat Group Bomag BPR 70/70 D Operating And Maintenance Instruction Manual page 19

n the fitting shows corrosion that impairs both function and
strength.
fittings are damaged or deformed, whereby the function and
n
strength of the hose - hose connection is impaired.
hoses are mixed up by mistake.
Only genuine BOMAG replacement hydraulic hoses ensure that
the correct hose type (pressure range) is used at the right location.
Working on the engine
Drain the engine oil at operating temperature – danger of scalding!
Wipe off spilled oil, catch running out oil and dispose of environ-
mentally.
Store used filters and other oil contaminated materials in a sepa-
rate, specially marked container and dispose of environmentally.
Working on electric parts of the machine
Before starting to work on electric parts of the machine disconnect
the battery and cover it with insulating material.
Do not use fuses with higher ampere ratings and do not bridge
fuses - fire hazard!
Working on the battery
When working on the battery do not smoke, do not use open fire!
Do not let acid come in contact with hands or clothes! When
injured by acid flush off with clear water and seek medical advice.
Metal objects (e.g. tools, rings, watch straps) must not come in
contact with the battery poles – danger of short circuit and burning!
For recharging remove the plugs from the battery to avoid the
accumulation of highly explosive gases.
Observe the applicable instructions when starting with an auxiliary
battery.
Switch off the charging current before removing the charging
clamps.
Ensure sufficient ventilation, especially if the battery is to be
charged in a closed room.
Dispose of old batteries according to regulations.
Working on the fuel system
Do not inhale any fuel fumes.
Avoid open fire, do not smoke, do not spill any fuel.
Catch running out fuel, do not let it seep into the ground and dis-
pose off environmentally.
Cleaning work
Do not perform cleaning work while the motor is running.
Do not use gasoline or other easily inflammable substances for
cleaning.
When using a steam cleaner for cleaning do not subject electrical
parts and insulation material to the direct jet or cover these items
beforehand.
BPR 70/70 D
Safety regulations
19